<div dir="ltr"><div dir="ltr">On Thu, Nov 19, 2020 at 6:58 PM spike jones via extropy-chat <<a href="mailto:extropy-chat@lists.extropy.org">extropy-chat@lists.extropy.org</a>> wrote:<br></div><div class="gmail_quote"><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><div lang="EN-US" style="overflow-wrap: break-word;"><div class="gmail-m_-7438190288747706691WordSection1"><p class="MsoNormal"><u></u><br></p><p class="MsoNormal">If you put that seam under a microscope, it would look like a ridge but not a groove.  This is important, for that seam is the site on which two similar mold halves were fused together.  The reason that is important is that there is more material along the fusion site than elsewhere, for that process of fusing the two pieces after the initial thermal-setting does not create the same number of bonds as the initial injection mold process.</p></div></div></blockquote><div><br></div><div>Except...most plastic bottles are blow molded. The "seam" is just where the two halves of the mold meet.</div><div><br></div><div><a href="https://www.youtube.com/watch?v=8W6P5KU5ONQ">https://www.youtube.com/watch?v=8W6P5KU5ONQ</a></div><div><br></div><div>-Dave </div></div></div>